HOW TO USE THE THERMOMETER
1. Press the on-off button to turn on the thermometer, The window will display 188.8 ME And a beep sound will be heard. This indicates that the unit is in working condition
2. Upon releasing the on-off button, last measured temperature will be showed for about two seconds with letter”M”under the degree sign, then 370C/98.6F, and then Lo C/Lo ‘ displayed
(if the room temperature is greater than 32.0 C/89.6F, it will be displayed rather than Lo C/LoF)
The flash C/F indicates the thermometer is ready to take a temperature
3. Take temperature by ORAL, UNDERARM(AXILLARY), or RECTAL method Oral use: Put the temperature prove beneath the tongue and close your mouth or about one minute Or until temperature is stabilized Underarm(Axillary) use: Wipe armpit with dry tower. place the prove in the armpit, lower arm and hold firmly unit temperature s stabilized. To avoid any influence from surrounding air, fold the arm over the chest, tightly covering The sensor under the arm
4. When the peak temperature is reached or temperature stabilizes the C/F Symbol stops flashing and sound an alarm (Bi-Bi-Bi, if temperature exceeds 37.8 C/100F It sounds Bi-Bi-Bi) at this point. Remove thermometer and read the temperature on displa Ignoring the completion beeps and leave thermometer in place for about 1-2 minutes, When you have a fever or more accurate measurement is required
5. Press the on-off button to turn off the power. If you forget to turn off the thermometer
CAUTIONS
1. Temperatures should be taken under adult supervision and stored from reach of Children. Prohibit children from biting hitting or removing the battery cover
2. Do not bend (avoid bending the prove more than 45 ) drop or disassemble the thermometer
3. Do not bite the sensor tip while taking oral temperatures. Simply place the tip under the tongue
4. Avoid exposing the thermometer to direct sunlight, high temperature or dirt
HOW TO CLEAN
Wash the area extending about 5cm(2″) from the tip of the thermometer with warm soap water or wipe the area with 70% isopropyl alcohol before of after each use Be sure to dry thermometer thoroughly before store in the case provided with the unit
HOW TO REPLACE THE BATTERY
When the battery is almost exhausted, the sign show in the display window
1. Remove the battery cover(see diagram)
2. Use a toothpick or insulated prove to remove the battery
3. 3. Insert the new battery NOTE: Ensure battery polarity is correct placed. The battery should be inserted with the positive side(+) facing up and the negative side(-) facing down
4. Replace and fasten the cover securely WARNING: Swallowing a button battery may be fatal to Do not attempt to recharge the battery Do not dispose the battery in or near fire as it may explode
Reviews
There are no reviews yet.